|
Posted by Randy Snyder on June 11, 2005 at 07:55:24: In Reply to: Posted by on June 10, 2005 at 14:46:42: The reproduction inner frames will need a little work to fit properly. The overall frame dimensions are correct. The problem is with the curved bend at the top where the inner frame slides down into the outer frame. This curve is incorrect. As you try to close the inner frame, it will bind and not close. I used a set of body panel vise-grips to give it more bend. It takes some time, a good eye, and some patience, but it can be done. MD Juan has supposedly redesigned his tooling for this bend. You can ask some vendors if these new inners are now in stock. My guess is if you bought one now it would be the old design. Randy Snyder
|