Print Page | Close Window

tranny spline shaft

Printed From: The CJ2A Page
Category: CJ-2A Discussion Area
Forum Name: Tech Questions and Answers
Forum Description: CJ-2A technical questions here
URL: https://www.thecj2apage.com/forums/forum_posts.asp?TID=44781
Printed Date: 19 Oct. 2019 at 3:22pm
Software Version: Web Wiz Forums 12.01 - http://www.webwizforums.com


Topic: tranny spline shaft
Posted By: Thad
Subject: tranny spline shaft
Date Posted: 19 May 2019 at 10:15am
I read that the diameter of the tranny shaft that goes into the pilot bearing is app .627 but my cj2a shaft is app .593 and the inside diameter of the pilot bearing is app .590, as accurate as I can measure. I believe this is all original. The pilot bearing guide will not  slide in the pilot bearing as it measures .630. Did the early column shift cj2a have different dimensions? Should I just put it back together and cross fingers? I believe they were mated ok when I removed the engine.
Thanks, Thad


-------------
Life is short. Buy a jeep



Print Page | Close Window

Forum Software by Web Wiz Forums® version 12.01 - http://www.webwizforums.com
Copyright ©2001-2018 Web Wiz Ltd. - https://www.webwiz.net