Round Muffler, Rear Exhaust Hangers |
Post Reply |
Author | |
Howard
Member Sponsor Member Joined: 17 Feb. 2006 Location: New Mexico Status: Offline Points: 976 |
Post Options
Thanks(0)
Posted: 19 Jan. 2007 at 7:54pm |
Hi Folks,
According to the books the cj2a had more than one style exhast system depending on S/N. These are my interpretations of the parts on 23353's exhaust system. In particular the mounting clamps and pieces. I made a few alterations but did not permanently change anything. Most of this was done as a dry run or 'trial' fit prior to further frame component disassembly and refurbishing. Refer to parts drawing for number locations.
Group 13-01
Location #2 and #4 are to be clamps only.
A clamp at position #2
The clamp above is obvious not an original style clamp. I would suggest this style, below, is.
Then, position 9,10,11,12. This fastens to the cross member in mid vehicle. On my version, note the shock absorber plates on each end of the rubber shock. This keeps the rubber from being cut from the bolts and adds strength to the assembly. These plates were evident in the original hardware removed.
This is my interpretation of how it may have been...
Postion # 8
Bracket #6 Located inside the right rear wheel well. Again, my interpretation, with the use of the sheet metal plates wrapping around the end of the rubber for the bolts.
Hope this helps someone.
Howard
Edit 4/09: Now that these have been in service awhile I find the clamp at position 9,10,11,12 as I made it has proven inadequate to take the constant heat from the pipe.
Edit 1/10: Upgrade photos Edited by Howard - 17 Jan. 2010 at 5:02pm |
|
Howard F Jewett
1946 CJ2A #23353 43 GPW 106505 USA #20366014 43 Bantam Trailer T3 #14844 52 M100 K1119 |
|
m606paz
Member Joined: 14 Nov. 2008 Location: Buenos Aires Status: Offline Points: 13 |
Post Options
Thanks(0)
|
Hi fellows!
Some of you may take the original muffler measures in order to make an original copy in my country? Diameter, length, location of inlet and outlet pipes.. Thanks in advance!! Regards
Edited by m606paz - 09 Feb. 2011 at 10:03pm |
|
Mariano Paz
1966 m606 1945 Willys MB |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |