body mounts |
Post Reply | Page <12 |
Author | |||||
Rus Curtis
Member Joined: 25 Mar. 2010 Location: Alabama Status: Offline Points: 1733 |
Post Options
Thanks(0)
|
||||
Thanks again, Phil Hey guys, anybody with the answer to this query? Using the Parts list (can be found in forum under CJ2A
Parts Project/Introduction) will show that there are liners at the #1 hold down (and all
others).
I was trying to figure out if the body mount bolt, which I'm
getting ready to replace - which has the head right in the floor of the
driver's floor board (I'm replacing that sheetmetal) - is properly a normal hex
head or a carriage bolt. It's apparently a hex head sticking up in
there. Using the Parts List, all hold down bolts are hex except for the rear deck #5. That's listed as a Step Bolt (looks similar to a carriage but a larger flatter head). That bolt at #3A (driver's side) goes into a captured nut from under the frame - no hole in the floor panel. As Terry explains. If too late for adding a captured nut inside the hat channel suggest an elevator bolt which has a flat head - and then add some good anti-squeak under the tank to create a good gap.
I don't see this location in the picture in this thread, or on my
tub. The hat channel runs under the step and the only bolt loaction in
that area goes to the brackets on the outside of the frame. Search "Hole To Nowhere" |
|||||
Rus Curtis
Alabama 1954 CJ3B Bantam T3-C |
|||||
Post Reply | Page <12 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |