Correct wire routing |
Post Reply |
Author | |
usmcpmi
Member Sponsor Member Joined: 01 Mar. 2006 Location: Elgin,Texas Status: Offline Points: 878 |
Post Options
Thanks(0)
Posted: 22 Sep. 2018 at 3:07am |
So, was there any follow-up on getting some pictures of the correct routing for the wiring system on a 2a? Like, how does the wire to the tail light run? Along the frame, or inside the tub? Thanks for any help!
|
|
'48 CJ2A/192948
'15 Wrangler Rubicon Mark G. |
|
DonH
Member Joined: 13 Feb. 2006 Location: Central Massachusetts USA Status: Offline Points: 132 |
Post Options
Thanks(0)
|
Starting at the front along the inside of the left frame behind the master cylinder, over the cross member and again inside the boxed frame and coming out of the frame through the opening at the rear and over the frame to the tail light. If you have a right tail light the right tail light harness is connected to the left harness near the left frame opening and runs along the rear cross member going over the top of the right frame rail to the right tail light. Sorry no photo, word picture only. Are you using a reproduction harness? DonH
|
|
1946CJ2A
|
|
usmcpmi
Member Sponsor Member Joined: 01 Mar. 2006 Location: Elgin,Texas Status: Offline Points: 878 |
Post Options
Thanks(0)
|
Yes, Rich (mogger7) made one for me.
|
|
'48 CJ2A/192948
'15 Wrangler Rubicon Mark G. |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |