Dana 18 transfer case shift fork issue |
Post Reply |
Author | |
Oldgreencj2a
Member Joined: 23 Oct. 2021 Location: America Status: Offline Points: 13 |
Post Options
Thanks(0)
Posted: 23 Oct. 2021 at 3:33pm |
Hey, I'm new to the form here. I am rebuilding the Dana 18 transfer case out of my '48 CJ2a, using a rebuild kit from Quadratec. My issue is that when the output shaft sliding gear is assembled on the output shaft, it rubs on the shift fork. The shift fork itself does not appear to be bent. Any ideas??
Thanks
Edited by Oldgreencj2a - 23 Oct. 2021 at 3:43pm |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |