Do ya think its toast? |
Post Reply |
Author | |
scoutpilot
Member Joined: 30 Dec. 2008 Location: Asheboro, NC Status: Offline Points: 4373 |
Post Options
Thanks(0)
Posted: 23 Oct. 2013 at 2:29pm |
F4-134 Oil Pump and Pressure Relief Ball. Well what used to be... Had some gas infiltration due to a bad fuel pump.
|
|
Oilleaker1
Member Joined: 06 Sep. 2011 Location: Black Hills, SD Status: Offline Points: 4406 |
Post Options
Thanks(0)
|
Sand the end plate with 36 grit and dress the ball ridge with a file, you'll be fine! Right? John
|
|
Green Disease, Jeeps, Old Iron!
|
|
TERRY
Member Sponsor Member Joined: 22 May 2007 Location: BOULDER COLORADO Status: Offline Points: 3396 |
Post Options
Thanks(0)
|
Or, pick up a new ball bearing of the correct size.
|
|
BOULDER 48 2A
|
|
Carlsjeep
Member Joined: 15 Jan. 2011 Location: Taylorsville Ky Status: Offline Points: 2642 |
Post Options
Thanks(0)
|
A lot depends on the wear on the gears and the bottom of the housing where the gears rest. The cover plate has a lot of wear which leads me to believe the same will be in the bottom of the gear housing and possibly on the gear teeth.
|
|
Life is only as good as you make it.
|
|
Oilleaker1
Member Joined: 06 Sep. 2011 Location: Black Hills, SD Status: Offline Points: 4406 |
Post Options
Thanks(0)
|
I was being sarcastic! You could mill off the plate and put a rebuild kit in it, but the ball is shot and not sure about the ball's seat. A new pump would be in order in my book. John
|
|
Green Disease, Jeeps, Old Iron!
|
|
scoutpilot
Member Joined: 30 Dec. 2008 Location: Asheboro, NC Status: Offline Points: 4373 |
Post Options
Thanks(0)
|
Replacement cast-iron oil pump should be here tomorrow. NOS fuel pump standing by for install. John, heh-heh, knew you knew better.
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |