tranny spline shaft |
Post Reply |
Author | |
Thad
Member Joined: 05 Jan. 2017 Location: Nobleboro Me Status: Offline Points: 205 |
Post Options
Thanks(0)
Posted: 19 May 2019 at 3:15pm |
I read that the diameter of the tranny shaft that goes into the pilot bearing is app .627 but my cj2a shaft is app .593 and the inside diameter of the pilot bearing is app .590, as accurate as I can measure. I believe this is all original. The pilot bearing guide will not slide in the pilot bearing as it measures .630. Did the early column shift cj2a have different dimensions? Should I just put it back together and cross fingers? I believe they were mated ok when I removed the engine.
Thanks, Thad
|
|
Life is short. Buy a jeep
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |