T90 cluster spacing |
Post Reply |
Author | |
Bob3b
Member Joined: 08 Mar. 2010 Location: Akron, Ohio Status: Offline Points: 3097 |
Post Options
Thanks(0)
Posted: 30 July 2021 at 6:20pm |
I’m Rebuilding a couple t90s for guys and am running into and issue with each. The instructions say “some need two washers on the small end”. I’ve never seen one that has not had both washers.
What I’m running into is with one washer in place on each end I’m getting .050 clearance but each third washer is .062. The cluster are supposed to have .012-..018 so I’m not sure how to make that happen. Any advice? Could I buy some shims that are .030 or .035 and use them? |
|
1946 CJ2A #23881
1953 CJ3b, nice! 1949 Jeepster 1947 Empire Model 90 1985 CJ10A Spen "S" Utility trailer Kubota l3400 |
|
BD1
Member Joined: 18 Dec. 2019 Location: Maine Status: Online Points: 630 |
Post Options
Thanks(0)
|
Extra thick thrust washers seem to be an issue with the rebuild kits. I wound up dressing off and re-using the old one on one end of mine last winter to get the correct freeplay.
|
|
BD
'47 CJ2a, Shiny on top! '55 CJ5 project |
|
Bob3b
Member Joined: 08 Mar. 2010 Location: Akron, Ohio Status: Offline Points: 3097 |
Post Options
Thanks(0)
|
I was sure thinking about that but the old one is so nasty
|
|
1946 CJ2A #23881
1953 CJ3b, nice! 1949 Jeepster 1947 Empire Model 90 1985 CJ10A Spen "S" Utility trailer Kubota l3400 |
|
IronAge52
Member Joined: 22 Aug. 2016 Location: San Diego Status: Offline Points: 257 |
Post Options
Thanks(0)
|
call John at Border Parts. been in business for 50 years in Spring Valley ca. tell him that Jerry sent you.
|
|
gearwrencher
|
|
Ron D
Member Joined: 27 Oct. 2019 Location: South Carolina Status: Offline Points: 1433 |
Post Options
Thanks(0)
|
1951 M38
1951 M100 |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |