Forum Home Forum Home > CJ-2A Discussion Area > Tech Questions and Answers
  New Posts New Posts RSS Feed - Front hub spindle nuts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Front hub spindle nuts

 Post Reply Post Reply Page  <12
Author
Message
SE Kansas 46 CJ-2A View Drop Down
Member
Member
Avatar
Sponsor Member x 2

Joined: 22 Jan. 2016
Location: S.E. Kansas
Status: Offline
Points: 1363
Post Options Post Options   Thanks (0) Thanks(0)   Quote SE Kansas 46 CJ-2A Quote  Post ReplyReply Direct Link To This Post Posted: 26 Apr. 2019 at 3:05pm
Originally posted by 46Willard 46Willard wrote:

I like to adjust the wheel bearings with the wheel/tire installed if possible. I grab the tire at the top and bottom and feel for the slightest amount of play. The term I was taught was "barely perceptible", similar to Bruce's no lash, no preload. Sometimes I will rest my forehead on the tire to help feel that slight play. I agree with Unkamonkey, that tightening the outer nut, tends to tighten the inner nut a little, so some times trial and error, to get the right setting. Also important to snug the inner bearing to seat it (squish grease). Seems like mo matter how precise I set the wheel bearings, after a few miles, the endplay will increase, but usually at an acceptable amount.
Your top and bottom check will work, but you must be certain that any movement isn't play in the steering knuckle upper and lower bearings. If they are in good shape then your technique would work fine.
46 CJ-2A #64462 "Ol' Red"



Back to Top
 Post Reply Post Reply Page  <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.