picture post test |
Post Reply |
Author | |
Steve..
Member Joined: 26 May 2020 Location: 54961 Status: Offline Points: 22 |
Post Options
Thanks(0)
Posted: 04 July 2020 at 3:15am |
I took these out of my 48 2A. I'm researching if i would need hub bushings with flanges or not.
Thanks Steve
|
|
Thanks for your help!
|
|
Steve..
Member Joined: 26 May 2020 Location: 54961 Status: Offline Points: 22 |
Post Options
Thanks(0)
|
I had no luck finding a better way to post pics. Please let me know the best way. Normally i would upload them to Photobucket and move on from there.
Thanks much Steve
|
|
Thanks for your help!
|
|
Ol' Unreliable
Member Joined: 25 Sep. 2016 Location: CO Springs CO Status: Offline Points: 4226 |
Post Options
Thanks(0)
|
If your shafts have the threaded ends, I think that means you need the flanged bushings, even if the threaded ends have been cut off. You have a Rzeppa short shaft and a Bendix long shaft. You will need to control the turning angle to accommodate the Bendix shaft, as it can't handle the same angle the Rzeppa shaft will. BTW, the pic is good but it's strange that it comes in between the "T" and "h"...
Edited by Ol' Unreliable - 11 July 2020 at 11:09pm |
|
There's a reason it's called Ol' Unreliable
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |