Forum Home Forum Home > The CJ2A Parts Project > Parts List > Transfer Case
  New Posts New Posts RSS Feed - Rear Output Shaft and Bushing
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Rear Output Shaft and Bushing

 Post Reply Post Reply
Author
Message
Howard View Drop Down
Member
Member
Avatar
Sponsor Member

Joined: 17 Feb. 2006
Location: New Mexico
Status: Offline
Points: 976
Post Options Post Options   Thanks (0) Thanks(0)   Quote Howard Quote  Post ReplyReply Direct Link To This Post Topic: Rear Output Shaft and Bushing
    Posted: 24 Feb. 2010 at 7:39pm
Group 18-04
Rear Output Shaft
Part # A1764 until exhausted as per G503 then use #A8841
Spicer # SP-18-362-4
One of these is a replacement from a dealer. It uses 3/4 x 16 TPI castle nut and no Cotter pin hole, instead of the 3/4 x 20 Tpi and cotter pin hole on the original.
Part #A987 Bushing
These are two different bushings, from two different vendors that goes in the end of the shaft to support the front output clutch shaft. The one on the right is more like the one tht is inside my OEM shaft.
This bushing is to fit properly on the shaft. It is to be finish reamed to .625 ID after being installed 9/16 of an inch below flush from the end of the shaft.
The fit here is critical for the proper function of the gears, shafts and adjustment to the Tapered Roller Bearings supporting this big shaft.
 
 
 
 
 
 
 


Edited by Howard - 24 Feb. 2010 at 7:41pm
Howard F Jewett

1946 CJ2A #23353

43 GPW 106505 USA #20366014

43 Bantam Trailer T3 #14844

52 M100 K1119
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.