Tail Light Wiring harness routing |
Post Reply |
Author | |
Handler1
Member Joined: 28 Dec. 2014 Location: Ancaster ON CAN Status: Offline Points: 77 |
Post Options
Thanks(0)
Posted: 21 Mar. 2017 at 11:32pm |
Good evening, I would really appreciate it if someone would send me a sketch of the routing for the Tail Light harness, just the portion from where it comes out of the boxed frame just in front of the rear cross member, rearward, to each of the tail light securement locations, thanks, don
|
|
timcj2a
Member Sponsor Member Joined: 19 July 2005 Location: Chula Vista, CA. Status: Offline Points: 801 |
Post Options
Thanks(0)
|
Hi Don,
I just did the same routing a few months ago with mine. The routing was all based on the original harness. Here are some photos. Mind you, I have the original NACO single tail light on the driver's side only. You can see the single wire loom clamp in the second photo. Hope this helps, Tim |
|
timcj2a
Member Sponsor Member Joined: 19 July 2005 Location: Chula Vista, CA. Status: Offline Points: 801 |
Post Options
Thanks(0)
|
I'll see if I can grab a photo of the front side in the morning.
|
|
Handler1
Member Joined: 28 Dec. 2014 Location: Ancaster ON CAN Status: Offline Points: 77 |
Post Options
Thanks(0)
|
Thanks a million! I wasn't sure if there was clearance between the frame rail and the tub. I didn't want to set the tub on only to find that it was jamming the wire harness. I was considering drilling holes through the cross member and supports, but I think I'll just stick with the original routing, thanks again,
don
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |