Trail - parade jeep |
Post Reply | Page <123 |
Author | |||
jeepcj559
Member Joined: 21 June 2018 Location: WV Status: Offline Points: 100 |
Post Options
Thanks(0)
|
||
[QUOTE=Flatfender Ben]While it’s up on the hoist don’t forget to cut those u-bolt threads off.
They’ve been known to get hung on things, like tall curbs while leaving parades |
|||
jeepcj559
Member Joined: 21 June 2018 Location: WV Status: Offline Points: 100 |
Post Options
Thanks(0)
|
||
Has any just flipped the Ubolt to go up instead of down? I think my car trailer has them that way.
|
|||
rocnroll
Member Sponsor Member Joined: 20 July 2005 Location: Tuscumbia, AL Status: Offline Points: 13585 |
Post Options
Thanks(0)
|
||
Might study that for a minute....I think you'll see the answer. |
|||
'47 CJ2A PU
'48 CJ2A Lefty "Common sense is not that common" |
|||
jeepcj559
Member Joined: 21 June 2018 Location: WV Status: Offline Points: 100 |
Post Options
Thanks(0)
|
||
|
|||
jeepcj559
Member Joined: 21 June 2018 Location: WV Status: Offline Points: 100 |
Post Options
Thanks(0)
|
||
|
|||
jeepcj559
Member Joined: 21 June 2018 Location: WV Status: Offline Points: 100 |
Post Options
Thanks(0)
|
||
Found a brand new Detroit locker cheap so it’s going in the back. We’re going to do a full floater in the back with the Dana 27 left over parts.
|
|||
jeepcj559
Member Joined: 21 June 2018 Location: WV Status: Offline Points: 100 |
Post Options
Thanks(0)
|
||
The Detroit and the new gears are in and the mesh and back lash has been checked
Edited by jeepcj559 - 11 Nov. 2019 at 10:08pm |
|||
jeepcj559
Member Joined: 21 June 2018 Location: WV Status: Offline Points: 100 |
Post Options
Thanks(0)
|
||
The rear drive shaft came back today. And got put in. It is about 2” shorter than when it came out of my cj5
|
|||
Post Reply | Page <123 |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |