Forum Home Forum Home > CJ-2A Discussion Area > How to information
  New Posts New Posts RSS Feed - Transfer case shifters
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Transfer case shifters

 Post Reply Post Reply
Author
Message
wood047 View Drop Down
Member
Member
Avatar

Joined: 18 Apr. 2011
Location: Spnaway, Wash.
Status: Offline
Points: 11
Post Options Post Options   Thanks (0) Thanks(0)   Quote wood047 Quote  Post ReplyReply Direct Link To This Post Topic: Transfer case shifters
    Posted: 02 Sep. 2019 at 7:06pm
I'm getting ready to pull the transmission and transfer case. I'm at the point of trying to take off the shifters on the transfer case. From what I can figure, the set screw on the one end comes off and then pull the other end with the zerk fitting. The pin is being stubborn and won't come. I removed the zerk and put in 1/4" NF bolt and tapped on that but still no movement. Anybody have some other tricks to get the pin out?

Thanks Michael   
Back to Top
SE Kansas 46 CJ-2A View Drop Down
Member
Member
Avatar
Sponsor Member x 2

Joined: 22 Jan. 2016
Location: S.E. Kansas
Status: Offline
Points: 1424
Post Options Post Options   Thanks (0) Thanks(0)   Quote SE Kansas 46 CJ-2A Quote  Post ReplyReply Direct Link To This Post Posted: 02 Sep. 2019 at 7:21pm
PB Blaster (not WD-40) liberally applied to the pin on both ends. It may take a day or two with several applications for the pin to come loose...or it may not if it has been in there for 70 years...

PB blaster is your best bet.

Way back when I turned wrenches for a living I did construct a miniature screw jack that pushed against the side of the transmission and the back side of the pin. It worked just long enough to pop it free. I would still start with PB Blaster though.
46 CJ-2A #64462 "Ol' Red"



Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.